新闻详情
What are the installation and disassembly steps of the shed curtain motor?
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp;Greenhouse curtain motorNow it has been widely used in many industries. Because of its good service life and controllability, it has been widely praised in many control fields, so it has been liked and favored by customers. There are many precautions for disassembly, cleaning, maintenance and other work in the later period. Reasonable maintenance will have a greater benefit for the service life of the shed curtain motor. Today Weifang Liwang Electric Co., Ltd. will share the installation of the curtain motor And what are the specific steps of disassembly?
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp; The shed curtain motor needs to be disassembled and inspected after being used for a period of time, so that it can be timely If you find a problem, you can also ensure the normal use of the greenhouse curtain motor equipment, but you must pay attention to some problems when disassembling, so that there will be no errors, so how do we disassemble and install the greenhouse curtain motor.
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp; (1) First remove the external wiring of the greenhouse curtain motor and mark , And then loosen the foot screws to separate the motor from the transmission machinery.
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp; (2) For the shed motors with rolling bearings, the bearings should be removed first For the outer cover, loosen the tightening screws of the end cover, mark the joint between the end cover and the housing of the chassis, and screw the removed screws to tighten the end cover into the end cover set on the motor Push the end cap out of the two screw holes.
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp; (3) Take out the brush from the brush holder, and mark the position of the neutral wire of the brush for the DC motor.
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp; (4) Dismantle the pulley or coupling on the shaft of the greenhouse curtain motor Sometimes it is necessary to add some kerosene in the gap between the motor shafts of the pulleys to make it lubricated and easy to disassemble.
0010010 nbsp; 0010010 nbsp; 0010010 nbsp; 0010010 nbsp; (5) When pulling out the rotor of the greenhouse pull-out motor, be careful not to touch The stator coil is damaged, and some rotors with a small weight can be drawn out by hand. If the weight is relatively large, use a lifting device to hang out.
Related News
- What protection does the inverter perform on the curtain motor of the greenhouse?
- How to maintain greenhouse greenhouse motors?
- Glass greenhouse construction design requirements
- Glass greenhouse construction requirements and performance indicators
- The technical standard of the shed curtain motor
- How to choose a suitable greenhouse motor
- What are the application characteristics and advantages of the greenhouse sliding screen motor
- What are the installation steps and precautions for the shed curtain motor?
- What are the benefits of glass greenhouse construction for rural tourism development
- How much is the cost of one mu in the rural greenhouse?
- The greenhouse company analyzes the precautions for greenhouse construction for you
- Greenhouse motor construction description
- Talk about the matters needing attention in the construction of glass greenhouse
- The construction of glass greenhouse should consider the influence of load and weather
- Analysis of greenhouse cost and its advantages and disadvantages!
- Description of technical standards for the curtain motor of greenhouses
- Characteristics and principles of greenhouse motor
- Description of the working principle of the greenhouse motor